 |
|
|
|
| Events of the 1st quarter 2008: |
|
|
|
By order of Minister of Ukrainian Ministry of Industrial Policy, Mr. KHOMENKO Andrey
Ivanovich is appointed General Director
of GTRPC "Zorya - Mashproekt".
|
|
For the period of 2007 the following engines of "Zorya - Mashproekt" production have been supplied for gas transportation systems
DG90 (9 units) - in Russia,
DN80 (9 units) - in Russia,
DU80 (2 units) - in Russia and Iran,
DT70 (2 units) - in Bulgaria,
DT71 (4 units) - in Kazakhstan.
At present the specified engines are at different phases of supply, installation and commission-ing.
|
|
For the period of 2007 the following engines of
"Zorya - Mashproekt" production have been commissioned and
entered the operation as gas pumping unit drives in gas transportation
systems
DG90 (12 units) - in Russia,
DU80 (2 units) - in Iran,
DT70 (2 units) - in Bulgaria.
|
|
In 2007, for marine application, eight 16MW and six 3MW engines as well as
5 various power gearboxes of "Zorya - Mashproekt" production have been manufactured and supplied to the Customers.
|
|
In January of 2007 at OJSC "Stirol Concern" site (Gorlovka, Ukraine) the gas
turbine co-generation power station GTPS-25S having electrical power of 24.6 MW and steam
productivity of 100 t/h with steam parameters of 4.1 MPa 445°Ñ was commissioned on "key-turn" basis.
All the equipment modules were supplied in container.
Since the natural gas pressure was not enough, the fuel gas boost compressor was used at the site.
The boiler can be used in heat recovery cycle and in autonomous mode as well.
|
|
The phase of detailed design is over for the new single shaft 5MW
engine intended for power generation application. Now, the phase of components manufacturing
has been started for carrying out of development tests and the first engine manufacturing process
has begun for the special tests.
|
|
The Contract has been signed and the production of big series of DU80
engines for application in gas industry has begun. The first supplies are planned for the end of 2008.
Totally more than 50 units of mechanical drives and the specified engines shall be supplied to the Customer.
|
|
|
